Polynomial Chaos Expansion method as a tool to evaluate and quantify field homogeneities of a novel waveguide RF Wien Filter

For the measurement of the electric dipole moment of protons and deuterons, a novel waveguide RF Wien filter has been designed and will soon be integrated at the COoler SYnchrotron at J\"ulich. The device operates at the harmonic frequencies of the spin motion. It is based on a waveguide structure that is capable of fulfilling the Wien filter condition ($\vec{E} \perp \vec{B}$) \textit{by design}. The full-wave calculations demonstrated that the waveguide RF Wien filter is able to generate high-quality RF electric and magnetic fields. In reality, mechanical tolerances and misalignments decrease the simulated field quality, and it is therefore important to consider them in the simulations. In particular, for the electric dipole moment measurement, it is important to quantify the field errors systematically. Since Monte-Carlo simulations are computationally very expensive, we discuss here an efficient surrogate modeling scheme based on the Polynomial Chaos Expansion method to compute the field quality in the presence of tolerances and misalignments and subsequently to perform the sensitivity analysis at zero additional computational cost.Comment: 12 pages, 19 figure

Implementation of mean-timing and subsequent logic functions on an FPGA

This article describes the implementation of a mean-timer and coincidence logic on a Virtex-5 FPGA for trigger purposes in a particle physics experiment. The novel feature is that the mean-timing and the coincidence logic are not synchronized with a clock which allows for a higher resolution of approximately 400 ps, not limited by a clock frequency.Comment: 15 pages, 11 figure

Performance prediction of riser termination devices using barracuda

In fluidized bed reactors, one of the locations where attrition is significant is cyclones. One way to reduce the attrition in cyclones is to reduce the amount of catalyst going into the cyclones. This is achieved by separating the catalyst particles from the combined gas solid flow before the stream enters the cyclones. Using a riser flow along with a riser terminator, some of the catalyst particles can be separated from gas stream. In this work, we will discuss how Barracuda has been used at The Dow Chemical Company to investigate two riser termination devices for separating catalyst particles from gas phase. The two types of riser terminators simulated are (1) flat disk and (2) slots-elbow, as shown below in Figure 1. The results indicate that the slots-elbow type terminator has an overall separation efficiency of more than 95% whereas the disk terminator has approximately 80% efficiency. Please click Additional Files below to see the full abstract

A Multidimensional Rasch Analysis of the Functional Independence Measure Based on the National Institute on Disability, Independent Living, and Rehabilitation Research Traumatic Brain Injury Model Systems National Database

A number of studies have evaluated the psychometric properties of the Functional Independence Measure (FIM™) using Rasch analysis, although none has done so using the National Institute on Disability, Independent Living, and Rehabilitation Research Traumatic Brain Injury Model Systems National Database, a longitudinal database that captures demographic and outcome information on persons with moderate to severe traumatic brain injury across the United States. In the current study, we examine the psychometric properties of the FIM as represented by persons within this database and demonstrate that the FIM comprises three subscales representing cognitive, self-care, and mobility domains. These subscales were analyzed simultaneously using a multivariate Rasch model in combination with a time dependent concurrent calibration scheme with the goal of creating a raw score-to-logit transformation that can be used to improve the accuracy of parametric statistical analyses. The bowel and bladder function items were removed because of misfit with the motor and cognitive items. Some motor items exhibited step disorder, which was addressed by collapsing Categories 1-3 for Toileting, Stairs, Locomotion, Tub/Shower Transfers; Categories 1 and 2 for Toilet and Bed Transfers; and Categories 2 and 3 for Grooming. The strong correlations (r = 0.82-0.96) among the three subscales suggest they should be modeled together. Coefficient alpha of 0.98 indicates high internal consistency. Keyform maps are provided to enhance clinical interpretation and application of study results

Discovery of Localized Regions of Excess 10-TeV Cosmic Rays

An analysis of 7 years of Milagro data performed on a 10-degree angular scale has found two localized regions of excess of unknown origin with greater than 12 sigma significance. Both regions are inconsistent with gamma-ray emission with high confidence. One of the regions has a different energy spectrum than the isotropic cosmic-ray flux at a level of 4.6 sigma, and it is consistent with hard spectrum protons with an exponential cutoff, with the most significant excess at ~10 TeV. Potential causes of these excesses are explored, but no compelling explanations are found.Comment: Submitted to PhysRevLet

The Study of TeV Variability and Duty Cycle of Mrk 421 from 3 Years of Observations with the Milagro Observatory

TeV flaring activity with time scales as short as tens of minutes and an orphan TeV flare have been observed from the blazar Markarian 421 (Mrk 421). The TeV emission from Mrk 421 is believed to be produced by leptonic synchrotron self-Compton (SSC) emission. In this scenario, correlations between the X-ray and the TeV fluxes are expected, TeV orphan flares are hardly explained and the activity (measured as duty cycle) of the source at TeV energies is expected to be equal or less than that observed in X-rays if only SSC is considered. To estimate the TeV duty cycle of Mrk 421 and to establish limits on its variability at different time scales, we continuously observed Mrk 421 with the Milagro observatory. Mrk 421 was detected by Milagro with a statistical significance of 7.1 standard deviations between 2005 September 21 and 2008 March 15. The observed spectrum is consistent with previous observations by VERITAS. We estimate the duty cycle of Mrk 421 for energies above 1 TeV for different hypothesis of the baseline flux and for different flare selections and we compare our results with the X-ray duty cycle estimated by Resconi et al. 2009. The robustness of the results is discussed.Comment: 27 pages, 6 figures, ApJ accepte

Measuring the Polarization of a Rapidly Precessing Deuteron Beam

This paper describes a time-marking system that enables a measurement of the in-plane (horizontal) polarization of a 0.97-GeV/c deuteron beam circulating in the Cooler Synchrotron (COSY) at the Forschungszentrum J\"ulich. The clock time of each polarimeter event is used to unfold the 120-kHz spin precession and assign events to bins according to the direction of the horizontal polarization. After accumulation for one or more seconds, the down-up scattering asymmetry can be calculated for each direction and matched to a sinusoidal function whose magnitude is proportional to the horizontal polarization. This requires prior knowledge of the spin tune or polarization precession rate. An initial estimate is refined by re-sorting the events as the spin tune is adjusted across a narrow range and searching for the maximum polarization magnitude. The result is biased toward polarization values that are too large, in part because of statistical fluctuations but also because sinusoidal fits to even random data will produce sizeable magnitudes when the phase is left free to vary. An analysis procedure is described that matches the time dependence of the horizontal polarization to templates based on emittance-driven polarization loss while correcting for the positive bias. This information will be used to study ways to extend the horizontal polarization lifetime by correcting spin tune spread using ring sextupole fields and thereby to support the feasibility of searching for an intrinsic electric dipole moment using polarized beams in a storage ring. This paper is a combined effort of the Storage Ring EDM Collaboration and the JEDI Collaboration.Comment: 28 pages, 15 figures, prepared for Physical Review ST - Accelerators and Beam

Spectrum and Morphology of the Two Brightest Milagro Sources in the Cygnus Region: MGRO J2019+37 and MGRO J2031+41

The Cygnus region is a very bright and complex portion of the TeV sky, host to unidentified sources and a diffuse excess with respect to conventional cosmic-ray propagation models. Two of the brightest TeV sources, MGRO J2019+37 and MGRO J2031+41, are analyzed using Milagro data with a new technique, and their emission is tested under two different spectral assumptions: a power law and a power law with an exponential cutoff. The new analysis technique is based on an energy estimator that uses the fraction of photomultiplier tubes in the observatory that detect the extensive air shower. The photon spectrum is measured in the range 1 to 200 TeV using the last 3 years of Milagro data (2005-2008), with the detector in its final configuration. MGRO J2019+37 is detected with a significance of 12.3 standard deviations ($\sigma$), and is better fit by a power law with an exponential cutoff than by a simple power law, with a probability $>98$% (F-test). The best-fitting parameters for the power law with exponential cutoff model are a normalization at 10 TeV of $7^{+5}_{-2}\times10^{-10}$ $\mathrm{s^{-1}\: m^{-2}\: TeV^{-1}}$, a spectral index of $2.0^{+0.5}_{-1.0}$ and a cutoff energy of $29^{+50}_{-16}$ TeV. MGRO J2031+41 is detected with a significance of 7.3$\sigma$, with no evidence of a cutoff. The best-fitting parameters for a power law are a normalization of $2.4^{+0.6}_{-0.5}\times10^{-10}$ $\mathrm{s^{-1}\: m^{-2}\: TeV^{-1}}$ and a spectral index of $3.08^{+0.19}_{-0.17}$. The overall flux is subject to an $\sim$30% systematic uncertainty. The systematic uncertainty on the power law indices is $\sim$0.1. A comparison with previous results from TeV J2032+4130, MGRO J2031+41 and MGRO J2019+37 is also presented.Comment: 11 pages, 10 figure